"HARNESSING THE POWER OF WATER"
|
|
|
Our Flow Waterjet Cutting Table 6' x 12' capacity
|
Environmentally responsible - Ebbco closed-loop water filtration system allows us to re-use our water many times over - so there is as little waste as possible
|
BENEFITS OF WATERJET CUTTING
 Photo courtesy of Flow International Corporation www.FlowWaterjet.com
Cuts virtually any hard material including (but not limited to):
Metal Stone Tile Rubber Plastic Foam Glass and more...
|
Why Waterjet?
Capable of cutting material up to 4" thick No Heat-Affected Zone - does not change the composition of the material at the cut site Superior cut-edge quality - clean edges virtually eliminate the need for further tooling. Cut and go - saves you time and money Tight nesting area maximizes material usage, thus reducing scrap and waste - saves you time and money Contact us for more details or to discuss the specifics of your project **Interesting Fact: Waterjet cutting uses pressure up to 60,000 psi (average house water tap pressure is about 60 psi)** |
